daremore78

Hello! I am developping a filtering board for analog signals (bandwidth of interest 300-5khz). I used for this purpose a lowpass Sallen key, a high pass sallen key (all butterworth configuration) and a passive RC low pass for adding a pole. I tried various Gain (3,5 , 5 ,8) on a breadboard and they all seemed ok but when I tried Gain = 10(10 for the first SK and 10 for the second. So the total is 100) I noticed a strange behaviour. (see the attachment - the comparison is with the Ltspice simulation). The strange thing is that if separated the two sallen key don't show any problem... Could be this due to sensitivity of circuit parameters to tolerance components ? Is maybe the impedance of the passivr RC too low ? It's only 143 ohm cause after that should be linked an ADC with impedance of 10khm thank you

Hi people ! I'am new to the world of electronic but i have a work for the university to do : design for 60 channels the following circuit with EAGLE (see image 1) I want to realize a little board (max 4x3,15 inch) so i was thinking to use a quad-opamp (so : 2 opamp for every channel (as you see from the image) = 30 quad-opamp) Now the problem is the space : someone can help designing just one of these quad-opamp with his relative capacitors/resistors ?? This is what I made (value of resistors/capacitors is not important) (see image 2) Thank you all , people !!!!!!!!!!!