Hi i think this is the good place to ask my question. i made this one
http://www.electronics-lab.com/project/0-30-vdc-stabilized-power-supply-with-current-control-0-002-3-a/#comment-173705
when i was testing my power supply, i found out that i couldn’t limit current. I test another motor and at that moment i saw that current is about 7 amps !!!!!When i disconnected the motor, voltage became 35V and i can’t change it with P1
Now neither P1 nor P2 work. but short circuit protection was working, but after doing few short circuit, LED didn't turned on pls help!