Jump to content
Electronics-Lab.com Community

H-Bridge


Watoto

Recommended Posts

Hello everyone! I need a help with my H-brdge(L6203) circuit to drive my Motor. I have 12V at Out-pot J1-1 and 0V at Out-pot J1-2. Ideally that is enough to drive the motor but when I connect the motor nothing happen and both Output terminals are at 12V. It seems that my Motor short cicuirt. When I manually connect the negative to ground, it works. However, I need to connect both terminal to the motor so that I can reverse direction when voltage output volatge from H-Bridge switch. I welcome all idea or solution. Is there any switch or isolation or relay I can use and how because I need to both terminal to control motor for direction

Thank you

Watoto

Link to comment
Share on other sites


From your description, it sounds as if you do not have enough current to your H bridge circuit. Check out this link for more on H bridge circuits. However, you might be able to just increase the current available to your present circuit and make it work.

http://home.cogeco.ca/~rpaisley4/HBridge.html

MP

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...