Jump to content
Electronics-Lab.com Community
Sign in to follow this  
boylesg

Reading and writing an EEPROM through a PC printer or serial port

Recommended Posts

I am using PonyProg2000.

I am trying to modify the small 8 pin EEPROM on a toner cartidge chip:





I have found a number of circuit schematics for a device that might work:

http://www.porlidas.gr/EPROM/EepPrgmEN.htm

and

http://www.chiprecharge.com/hardeng.html

I have tried the simple (1 resistor) version of the parallel port device on the second web page but, probably not surprisingly, it didn't work with PonyProg2000.

I was going to try the circuit on the former webpage.

Can anyone guide me as to which of these few circuits is likely to work?

And can you tell me what sort of protocol I would need to select in PonyProg2000 setup and also what device I would need to select....presumeably one of the I2C bus 8 bit devices.

Share this post


Link to post
Share on other sites

I've already told you via private message: DON'T POST THE SAME THING MORE THAN ONCE, it's treated as spamming and does not increase your chance of a helpful response.

This is your FINAL WARNING, do it again and you'll get banned.

MODERATOR.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...