Jump to content
Electronics-Lab.com Community

Checking Mosfets


pier

Recommended Posts

Hello,

While checking the N Channel Mosfet. I put the multimeter in the Beep mode (continuity mode)

Probing the -ve probe at the Mosfet Drain (tab), the +ve probe at the Source pin - the multimeter reads 500+ ohms which is the body diode I think.

Then

Still probing the -Ve on the Drain
I touch the +ve probe on the gate for a moment and then probe it back on the source it shows a dead short.

I don't know why this happens. Any body knows about this, please share.

The mosfet I used is FDD13AN0 from Fairchild initially

I tried the same with the:
BUK919 from NXP
NTD5867NL and a couple more and all show the same.

Regards
Pier

Link to comment
Share on other sites


  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...