Jump to content
Electronics-Lab.com Community

Micro USB battery charger and 3.3V supply


Guest Kaxsp

Recommended Posts

Guest Kaxsp

Hi,

I would like to ask you for advise and correction in case it is wrong. I wanted to change this power supply by usb which is working rightly in my device
to one using lion/lipo batteries.

So I did this schematic

using
http://www.micrel.com/_PDF/mic5305.pdf and
http://datasheet.octopart.com/MCP73832T-2ACI-OT-Microchip-datasheet-16123459.pdf

What do you think about it? Will it protect enough my batteries? Do you see any mistake or something could be improved?

Thank you!

Link to comment
Share on other sites


Why is your schematic an awful looking negative image?? admin: please be polite

The 3.3V regulator will stop working long before the battery voltage drops to 3.2V.

What will prevent the battery voltage from being discharged too low? You need a protection circuit that disconnects the load on the battery when its voltage drops below 3.2V.

Link to comment
Share on other sites

Guest Kaxsp

Well, sorry for the negative image, it is just a printscreen of my current design.

I changed my schematic again to this one


This schematic is divided in 2 parts. From LiPo to right is based in my current schema powered only by USB 5V. And LiPo to left is what i added based on this design
https://www.sparkfun.com/datasheets/Prototyping/Batteries/LiPo-Charger-Basic-v10.pdf

So, having this all together, do you think is there any error? Should I put any component between these two schematics? I am specially worried about when the battery is full and the voltage drops..

Thank you

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
  • Create New...