Year: 2016

circuitbasics.com writes: In this tutorial, I’ll explain how to set up an LCD display on an Arduino, and show you all the functions available to program it (with examples). The display I’m using here is a 16×2 LCD display that I bought for under $10 on Amazon....

A tiny pixel font rendered to an LCD display, in under 1K program space. by Zach: For the Hackaday 1k challenge, I'm attempting to pack a small pixel-based font and rendering to LCD in under 1K. The project has already been developed in C, but the file size was much larger. This...

In this instructable by gustavio101 you will know how to make a capacitance meter using Arduino displayed on the TM1637 display with a range from 1 uF to 2000 uF. To build this project you need the following parts: Resistors 1x: 220 Ohm 1x: 10 kOhm, 8000 Ohms also would...

Jan Ostman has a nice build log on his open-source DIY touch synthesizer the Tiny-TS, that is available on Hackster.io: The Tiny TS is a credit card sized (100x65mm) fully open-sourced synthesizer with a 1-octave capacitive touch keyboard. An open-source DIY touch synthesizer -...

A scalable development kit integrates ST SensorTile with Valencell's Benchmark biometric sensor system to accelerate smart wearable and IoT product development. By Graham Prophet @ edn-europe.com Valencell (Raleigh, North Carolina) is a company active in high-performance biometric...

The H-Bridge Motor Driver Module Based on TB6549HQ IC from Toshiba, is a full-bridge driver IC for DC motors that uses an LDMOS structure for output transistors. High-efficiency drive is possible through the use of a MOS process with low ON-resistance and a PWM drive system. Four...

Dual channel Compact  Relay driver module can be controlled by feeding 2-12V trigger voltage, Very useful project for application like Micro-Controller based projects, Remote controller, Lamp on Off, and any circuits which required isolated 5A current and high voltage switching by...

In this tutorial at hackster.io you will learn how to log data from LM35 temperature sensor values to an SD card and store it as CSV file. In order to build this project you need the following parts: Arduino UNO idIoTware Shield USB-A to B Cable SD Card (up to 8GB)...