Year: 2021
Smartpixels.app Lighting Control Project used to control Christmas lights
story by Tomasz Siroń I would like to present a project developed with a passion for almost 10 years. It is a non-commercial installation of lights controlled via the Internet. The user can control the illumination in real-time using the panel on the website. I installed...
Continue ReadingPIEEG — A Low-Cost, Raspberry Pi Based Brain-Computer Interface
The study of the electrical waves within the brain as a check for seizure activity relating to sleep disorders, brain tumors or epilepsy, has resulted in a parallel need for affordable EEG-based consumer applications in the healthcare center. Electronics, EEG, BCI, and neutral network...
Continue ReadingLoRa Hat Expansion For Raspberry Pi Starts at $40
Known for its DIY Robots and Hats for single board computers, SB Components has launched a crowdfunding campaign for its newest devices, LoRa Modules 868/433/915MHz -- a LoRa HAT for Raspberry Pi and a LoRa Expansion for Pico, designed for data transmission of up to 5km with low power...
Continue ReadingInfineon Technologies 6EDL7141 Gate Driver IC
Infineon Technologies 6EDL7141 Gate Driver IC is designed for 3-phase BLDC or PMSM motor drive applications. The 6EDL7141 features three half-bridge drivers, each capable of driving a high side and low side N-type MOSFET. Furthermore, the device is provided with programmable dead time...
Continue Readinge-con Systems launches 4K HDR USB 3.1 UVC camera based on AR0821
High Dynamic Range | Large pixel size (1/2” sensor) | 1080p@60 & 4K@30 fps e-con Systems Inc., a leading embedded camera solutions provider launches an 8MP USB 3.1 color HDR camera See3CAM_CU81 based on the AR0821 CMOS image sensor from On Semiconductor, with an inbuilt Image...
Continue Reading6V – 2.5Ah Sealed Lead-Acid Battery Charger
This dual-level float charger was designed for a 6V (three 2V cells) 2.5Ah battery. D2 LED was added for visual indication of charge completion, D3 indicates power, D4 LED presents overcharge condition, etc. 6V lead-acid battery charger is built using the UC3906 chip. UC3906 contains...
Continue ReadingFull Wave Rectifier Using Single Supply OPAMP
This is a Full wave rectifier project built using MAX44267 dual OPAMP which provides true zero output with a single supply. The circuit converts Bipolar/AC input into full-wave output. CN1 is provided for sinewave input, CN2 helps to connect the power and output. Operating supply 15V...
Continue ReadingUTP, FTP, S/FTP? Small Refresh Might Be Useful
Are you also sometimes not sure whether you are using the correct data cable acronyms that are mostly used for Ethernet? UTP vs FTP, STP vs FTP. Let’s have a look at the difference between them. Today we already know that if someone 20-30 years ago felt that the Internet would be a...
Continue Reading