Author: mixos

The Mini Infra-Red Remote Robot Controller shield for Arduino Nano is designed to drive mini mobile robots. Low voltage DC Motor controller interface allows Infrared wireless control of two DC motors, two PWM and 2 Direction signal outputs to drive two motors separately. TB6612 IC is...

Use PiSupply's PaPiRus ePaper display to monitor your network with a Raspberry Pi. Over the past few days I have been converting my “Speedtest-cron” code to work on the PaPiRus from PiSupply. Whilst going over the code, I decided to start a new Git Repository and rename this...

Synchronous four-switch buck-boost controller suits transport and medical use A 150V high efficiency four-switch synchronous buck-boost DC/DC controller, the LTC3777, by Analog Devices operates from input voltages above, below or equal to the regulated output voltage and had an...

Acknowledged as the UK’s leading source of advanced embedded technology, Solid State Supplies Ltd. now offers the world’s smallest Bluetooth® Low Energy (BLE) SiP module from Silicon Labs. With a package size of 6.5mm x 6.5mm x 1.4mm the BGM11S Blue Gecko SiP (System in Package)...

Mare @ e.pavlin.si designed a single cell Li-Ion battery pack simulator to facilitate the testing process of a new device. Modern battery operated portable devices use smart battery packs. Every new development of an electronic medical device must follow strict design flow defined by...

The complete electronics lab on your desk. Oscilloscope, waveform generator, programmer & debugger, VCOM, host device and more. OMNIBOARD is is a versatile, portable electronics workbench. I have created the OMNIBOARD to make electronics easier and more affordable, to put in your...

The MicroUSB-connected ScanaQuad series of 4-channel logic analyzers from Ikalogic perfectly fit serial protocols debugging and diagnostic purposes for the like of I2C, SPI, RS232, CAN or 1-Wire. By Julien Happich @ eenewseurope.com Smaller than a matchbox and available in four...

The gen4-4DPi range are Primary Display’s for the Raspberry Pi* A+, B+, Pi2, Pi3, Pi Zero and Pi Zero W, which display the primary output of the Raspberry Pi, like what is normally sent to the HDMI or Composite output. It features an integrated Resistive Touch panel or Capacitive...