maroelawerner @ instructables.com has a tutorial on how to display temperature data on an Android or iOS device using Arduino and Blynk app. In this Instructable I am going to attempt to show you how to put together a little project to use the Blynk app (optainable at...

Maurizio @ dev.emcelettronica.com has tipped us with his latest article on how to implement embedded Ethernet on any mcu. The article shows the basic principle of Ethernet implementation. Usually We need embedded systems inside devices, particularly the so-called intelligent devices,...

Bob @ robertgawron.blogspot.com has posted a Geiger-Muller project that can be used with Arduino or any other microcontroller board. The Geiger–Müller counter is a relatively simple tool to measure ionizing radiation. To increase sensitivity, construction presented here contains...

Bob has tipped us with his latest project. It's a 5V to 400V DC-DC Converter based on MC34063 IC and can be used in various projects such as Geiger–Müller counters. A small and cheap 5V/400V DC/DC converter can be useful in many DIY projects, e.g Geiger–Müller counters. I...

jollifactory @ instructables.com has published a large 8x8 LED Matrix Display which is driven by a MAX7219 and Arduino. For this project, we will be building a single color large LED matrix display which is made up of a few large 8x8 LED matrix modules daisy-chained together. Each...

In this video we learn how to use this 8x8 RGB LED matrix. This matrix is using the WS2812 driver and it is great, because each LED is individually addressable. Only one microcontroller pin is required to control all the LEDs, and you get 24 bit color for each LED. 8x8 RGB Led...

Brett Killion has published his Arduino shield a Network Analyzer on an Arduino Shield which covers from 0-72MHz. The network analyzer shield uses an Analog Devices AD9851 DDS chip clocked at 180MHz which will output a sine wave at any frequency from 0Hz and 72MHz. The DDS output is...

TC-Engineering has documented their efforts to program a Spartan 6 FPGA using a DIY PCB. The hardware part and software are discussed on the link below. I’ve been thinking about building stuff with FPGA’s for a while, and usually get turned away because FPGA’s are considerably...