Introduction IoT hardware specialist, Seeed Studio, recently released a very impressive 'Router' (more than a router actually) and we'll like to take an intensive look at it. So for this article, we will be reviewing the LinkStar-H68K multimedia router and discussing the features that...

The VAR-SOM-MX93 is based on NXP’s i.MX93 newest application processor, offers ML, power efficiency, and cost-effective advantages Variscite, a leading worldwide System on Module (SoM) designer, developer, and manufacturer, today announced new, state-of-the-art SoM for...

The Bosch SensorTech BME688 4-in-1 pressure, humidity, temperature, and gas sensor has replaced the HTS221 humidity sensor and the LP22HB barometric pressure sensor on the MKR IoT Carrier Rev2 board for Arduino MKR boards, and the LSM6DSOX has been replaced the LSM6DS3. The Arduino MKR...

Microchip Technology WBZ451 Curiosity Board is an efficient and modular development platform. It supports rapid prototyping and demonstrates the features, capabilities, and interfaces of Microchip's BLUETOOTH® Low Energy and Zigbee RF Module (WBZ451PE). Features WBZ451PE...

Synaptics’ SYN4778 GNSS IC delivers 80% lower power consumption in a 30% smaller package with 50% greater accuracy. Addressing the challenge of a GNSS receiver consuming a high percentage of available power in battery-based IoT devices, Synaptics Inc. unveiled its SYN4778, claimed...

The Pixhawk RPI CM4 Baseboard is a controller board designed to interface with the Pixhawk flight controller and the Raspberry Pi single-board computer. It allows users to connect the Pixhawk flight controller to the Raspberry Pi, enabling the use of the Raspberry Pi as a companion...

The BMR473 digital non-isolated PoL converter from Flex Power Modules is now available in a surface-mount format with solder bump terminations. This new mechanical version is also suitable for reverse mounting during reflow-soldering. Dimensioned just 19 x 13 x 7.5 mm, the device...

The Cytron Maker Feather AIoT S3 is an ESP32-S3 board that fits the Adafruit Feather form factor. It is good for makers and STEM education because it has LEDs for GPIOs, a buzzer, expansion headers and connectors, and support for CircuitPython and Arduino. The WiFi and Bluetooth LE IoT...