...

story by Tomasz Siroń I would like to present a project developed with a passion for almost 10 years. It is a non-commercial installation of lights controlled via the Internet. The user can control the illumination in real-time using the panel on the website. I installed...

The study of the electrical waves within the brain as a check for seizure activity relating to sleep disorders, brain tumors or epilepsy, has resulted in a parallel need for affordable EEG-based consumer applications in the healthcare center. Electronics, EEG, BCI, and neutral network...

Known for its DIY Robots and Hats for single board computers, SB Components has launched a crowdfunding campaign for its newest devices, LoRa Modules 868/433/915MHz -- a LoRa HAT for Raspberry Pi and a LoRa Expansion for Pico, designed for data transmission of up to 5km with low power...

Infineon Technologies 6EDL7141 Gate Driver IC is designed for 3-phase BLDC or PMSM motor drive applications. The 6EDL7141 features three half-bridge drivers, each capable of driving a high side and low side N-type MOSFET. Furthermore, the device is provided with programmable dead time...

High Dynamic Range | Large pixel size (1/2” sensor) | 1080p@60 & 4K@30 fps e-con Systems Inc., a leading embedded camera solutions provider launches an 8MP USB 3.1 color HDR camera See3CAM_CU81 based on the AR0821 CMOS image sensor from On Semiconductor, with an inbuilt Image...

This dual-level float charger was designed for a 6V (three 2V cells) 2.5Ah battery. D2 LED was added for visual indication of charge completion, D3 indicates power, D4 LED presents overcharge condition, etc. 6V lead-acid battery charger is built using the UC3906 chip. UC3906 contains...

This is a Full wave rectifier project built using MAX44267 dual OPAMP which provides true zero output with a single supply. The circuit converts Bipolar/AC input into full-wave output. CN1 is provided for sinewave input, CN2 helps to connect the power and output. Operating supply 15V...