Category: Arduino

This project will help you to easily develop an Arduino compatible project that requires 4 x -7Segment 0.5″ displays. The project consists of an Atmega328 microcontroller, 4 x BC847 NPN transistors to drive the common cathode displays. All displays are used in multiplexing...

This project will help you to easily develop an Arduino compatible project that requires 3 x 7-Segment 0.5″ displays. These are common cathode displays that use multiplexed configuration, BC847 transistor drives 3 x common cathodes, all display segments are connected to the...

This is an Arduino compatible board for creating 2 Digit Display projects. The circuit operates with 5V DC, Connector CN1 is provided for bootloader programming and Arduino firmware upload. A new Atmega328 chip requires a bootloader and Arduino firmware programming, Connector CN1 helps...

This is an Arduino compatible board that contains an Atmega328 microcontroller and Bipolar Stepper Motor Driver chip STK682-010. This Hybrid IC from ON Semiconductor can deliver up to 2.5A current and it can have an input supply up to 32V DC. It has multiple micro-stepping options such...

1. Introduction The project is a simple example showcasing a quick way to setup an Arduino with a USB Host Shield as a USB CDC Host capable of communicating with the BleuIO Dongle. When a BleuIO Dongle is connected to the USB port, the BleuIO Dongle will start advertising. It will...

The EEWeb Design Contest First Edition sponsored by Arduino and Altium is now open for submissions. This inaugural contest challenges hardware design enthusiasts from all over the world to develop an imaginative and innovative design project of a motor control system with the Arduino...

The latest entry in the Arduino Pro range is a sensor-packed edge AI board built in a very small footprint. Arduino entered into a partnership with Bosch to launch this new product that comes with a totally new form factor and boasts of edge AI acceleration, thanks to the 4 low-power...

This is an easy-to-make LED dimmer using RF remote control. The project is capable of driving a load up to 24W (2A X 12V LED). Any 12V single or 12V LED strip can be used. This is an open-source Arduino compatible hardware that has Atmega328 microcontroller, Potentiometer, MOSFET, 5V...