ICP12 USBSTICK, A New Tool for Signals Control & Monitoring
McuProductsToolsUSB

ICP12 USBSTICK, A New Tool for Signals Control & Monitoring

iCircuit Technologies had produced the iCP12 usbStick, a mini size 28 pin USB PIC IO development board and a good tool for signal monitoring (as oscilloscope), data acquisition and circuit troubleshooting at 1mSec/Samples period. The iCP12 usbStick is a PIC18F2550 based USB...

Continue Reading
11.836
Views
2 Comments
Micro Maestro 6-Channel USB Servo Controller
MotorProductsUSB

Micro Maestro 6-Channel USB Servo Controller

The Micro Maestro is the first of Pololu’s second-generation USB servo controllers. The board supports three control methods — USB for direct connection to a PC, TTL serial for use with embedded systems, and internal scripting for self-contained, host controller-free applications —...

Continue Reading
5.766
Views
0 Comments
Using HealthyPi with a PC for ECG,Respiration & SpO2
Test/MeasurementsUSB

Using HealthyPi with a PC for ECG,Respiration & SpO2

Ashwin K Whitchurch, Venkatesh Bhat, and Manikandan S @ hackster.io build a PC based ECG,Respiration & SpO2 monitor. We introduced the HealthyPi as a HAT add-on for the Raspberry Pi, turning it into a full-featured, medical-grade open patient monitor. However, we realized later...

Continue Reading
5.020
Views
0 Comments
Analog Discovery USB isolation
USB

Analog Discovery USB isolation

Bob tipped us with his latest article. He writes: Back when I was developing the PSU burner, I wanted to have the Analog Discovery isolated from the common ground, to avoid noise and other issues. Since I did not have a way to do this, I ended up using a laptop on battery for...

Continue Reading
3.966
Views
0 Comments
FONA808 USB Interface
McuUSB

FONA808 USB Interface

Jesus @ jechavarria.com tipped us with his latest project. He writes: For several months I’m working with FONA808 modules from Adafruit to make a portable, web-based locating system. This modules are based on the SIM808 module from SIMCOM manufacturer, and integrates both GSM and...

Continue Reading
4.277
Views
0 Comments
Installing The Micronucleus Bootloader To An ATtiny Via Arduino
ArduinoMcuUSB

Installing The Micronucleus Bootloader To An ATtiny Via Arduino

In order to be able to upload Arduino sketches directly to the ATtiny84 over USB without the need to use a programming device, Shawn Hymel, an electrical engineer at Sparkfun Electronics, had published a guide showing how to install the micronucleus bootloader, which supports virtual USB...

Continue Reading
11.139
Views
0 Comments
MalDuino, The Open Source BadUSB
ArduinoProductsUSB

MalDuino, The Open Source BadUSB

Firmware is a type of software that provides control, monitoring and data manipulation of engineered products and systems. A USB device firmware hack called BadUSB was presented at Black Hat USA 2014 conference, demonstrating how a USB flash drive microcontroller can be reprogrammed to...

Continue Reading
16.222
Views
0 Comments
USB Volume Control and Caps Lock LED
ArduinoUSB

USB Volume Control and Caps Lock LED

p_leriche @ instructables.com build a USB volume control which is simple, cheap and extensible. Check it out: I'm not the first person to publish an Instructable for a USB volume control, but I think this one is about as simple and cheap as it gets, and at the same time can be...

Continue Reading
5.716
Views
0 Comments
Get new posts by email:
Get new posts by email:

Join 97,426 other subscribers

Archives