Search Results for : arduino uno

A Sweden-based consumer electronics and computers retail specialist, Solder Party has released its FlexyPin Adapter that gives the Raspberry Pi Pico an Uno form factor. With the help of FlexyPins, the board allows the Raspberry Pi Pico to be used with Uno shields without having to...

This month oemsecrets.com are giving away 2 x learning Arduino starter kits including the ELEGOO UNO R3 Starter Kit and the ELEGOO 37 in 1 Sensor Modules Kit. Simply follow the link below to enter. Read on for more information about the learning starter kits. About the Kits The UNO...

ZigUNO is a development board that allows users to create custom Zigbee devices. It is compatible with the Arduino UNO shields and shares the same size as Arduino UNO. It comes with the Ebyte E18-MS1 module equipped with TI SimpleLink CC2530. TI (Texas Instruments) SimpleLink CC2530 is...

Waveshare has unveiled the CM4-Duino, an Arduino-compatible baseboard for the Raspberry Pi Compute Module 4. The Compute Module has the same form factor as the Arduino Uno R3 and supports the conventional Arduino's GPIO header. Hence permitting the use of most Arduino shields and...

The project presented here is a low-cost solution to control high power brushed DC motor speed and direction. Traditional DC motor controllers are based on solid-state circuitry known as H-Bridge. Here we have made an H-bridge configuration using high current 2 x relays which can...

Including 3 x Arduino Nano IoTs, 3 x Arduino Nanos and 3 x Arduino Uno Rev 3s in partnership with Farnell This month oemsecrets.com has teamed up with Farnell to give away 9 development boards from Arduino including 3 x Arduino Nano IoTs, 3 x Arduino Nanos and 3 x Arduino Uno Rev...

1. Introduction The project is a simple example showcasing a quick way to setup an Arduino with a USB Host Shield as a USB CDC Host capable of communicating with the BleuIO Dongle. When a BleuIO Dongle is connected to the USB port, the BleuIO Dongle will start advertising. It will...

This is an open-source Arduino compatible board that enables you to build a 4 channel RF remote control. The project consists of an Atmega328 microcontroller, 4 tactile switches, nRF24L01 2.4Gz RF Transceiver Module, power LED, function LED, and 3.3V regulator. The operating supply is...