Search Results for : PCB

Designed with makers in mind, this cost-effective Piskey Atto handles most of the issues developers face with some of the available development boards. “We recently started creating DIY projects on our YouTube channel and we ran into a similar issue, time and again. Most of the...

This Arduino shield helps to drive various loads like a solenoid, valve, motor, inductive actuator, heater, and bulb. A wide supply range 8V-60V and a load current of 2.7A allows it to be used with a variety of actuators. The board can be used as a stand-alone driver or it can be...

The EVAL_AUDAMP24 e-mode GaN HEMT-based evaluation board from Infineon Technologies is a 2-channel, 225W/ch (4Ω at ±43V) or 250 W/ch (8Ω at ±63V) half-bridge class D audio power amplifier for high-end Hi-Fi audio systems. This evaluation board demonstrates how to use the IGT40R070D1...

This sound sensor with Relay driver shield for Arduino Nano can be used to develop sound-activated ON/OFF switch or other projects that require sound senor. LM358 op-amp is used as the amplifier, 1st op-amp amplifies the microphone signal, and 2nd op-amp works as a half-bridge...

This is a simple power supply that provides an adjustable output voltage with an adjustable current limit. In such a small package, both these features make the power supply unique. The output voltage is adjustable range 1.2V to 6V DC and current limit range adjustable up to 1.5A,...

BLYST Nano is a tiny ARM Cortex Module with Bluetooth and 30 I/O, but next product BLYST840 is a finger-tip size, 32-bit ARM Cortex-M4F module with Bluetooth 5 and 46 I/O; a powerful upgrade of a system on a module indeed. Built around the Nordic nRF52832 Bluetooth SOC and the...

Measuring about 32 x 30 mm in footprint, Palmer’s fully-functional development board is a very small Linux-based single-board computer built around an ARM Cortex A7 SoC and targets IP cameras. “There are no solutions yet that can run a real OS like Linux that can be integrated by...

  This project consists of 20 non-contact infrared reflective sensors and each sensor provides an analog output. QRD114 sensor is the heart of the project which includes Infrared LED and photosensor.  The output of each sensor is high and goes low as objects or lines...