login
This is the image preview of the following page:
13.8V 2A Power Supply using LM338
[Customadds id=643821] Introduction This power supply appeared in the summer issue of Elektor 2000 without a PCB layout. So, I decided to build a PCB using Cadsoft EAGLE Lite edition following the Elektor’s schematic and introducing some changes. The power supply uses through-hole parts w... Read More
Image Downloads:
- full (1024x768)
- thumbnail (150x150)
- medium (850x638)
- medium_large (640x480)
- large (640x480)
- 1536x1536 (1024x768)
- 2048x2048 (1024x768)
- re_large (783x600)
- re_xxmedium (290x230)
- re_xmedium (359x236)
- re_medium (420x320)
- re_a_xsmall (186x174)
- re_xsmall (125x96)
- crp_thumbnail (292x236)
- menu-24x24 (24x18)
- menu-36x36 (36x27)
- menu-48x48 (48x36)
- woocommerce_thumbnail (300x225)
- woocommerce_single (600x450)
- woocommerce_gallery_thumbnail (100x100)
- wp_rp_thumbnail (150x150)
- wp_rp_thumbnail_prop (150x113)
RELATED POSTS
29 June, 2016 AVR vs PIC: The case of the candle
10 February, 2017 Building A Tiny Portable Time-lapse Camera
21 May, 2024 FOCn BLDC Motor Driver – A ESP32-S3-based module that supports SimpleFOC
6 October, 2016 NUT4NT, Open-Source 4-Channel GNSS Receiver Development Board
31 August, 2022 SeeedStudio Unveils reComputer J101/J202 – Carrier Boards for Jetson Nano/Xavier NX/TX2 NX Modules
27 February, 2021 Diodes’ AL5810Q 60 V adjustable current up to 200 mA linear LED driver offers excellent stability
