login
This is the image preview of the following page:
Low noise Mini Electret Microphone PreAmplifier
[Customadds id=643821] This single supply microphone pre-amplifier amplifies the output signal of an electret capsule microphone to audio line levels. An op-amp is used as a trans-impedance amplifier to convert the output current from the microphone into a signal-level voltage. The circuit works ... Read More
Image Downloads:
- full (1566x1133)
- thumbnail (150x150)
- medium (850x615)
- medium_large (640x463)
- large (640x463)
- 1536x1536 (1536x1111)
- 2048x2048 (1566x1133)
- re_large (783x600)
- re_xxmedium (290x230)
- re_xmedium (359x236)
- re_medium (420x320)
- re_a_xsmall (186x174)
- re_xsmall (125x96)
- crp_thumbnail (292x236)
- menu-24x24 (24x17)
- menu-36x36 (36x26)
- menu-48x48 (48x35)
- woocommerce_thumbnail (300x225)
- woocommerce_single (600x434)
- woocommerce_gallery_thumbnail (100x100)
- wp_rp_thumbnail (150x150)
- wp_rp_thumbnail_prop (150x109)
RELATED POSTS
8 September, 2016 Hall sensors consume no more than 1.6 mA
4 April, 2018 Introduction to DigiSpark – A Smaller, Cheaper and Powerful Arduino board
28 June, 2021 World Leading: Fibocom FG360 5G Module (MediaTek T750 Platform) Got FCC Certificate Before MWC 2021
15 September, 2015 Measure small currents without adding resistive insertion loss
22 June, 2022 Nordic Thingy:53 gets the Edge Impulse firmware for rapid IoT prototyping
23 May, 2016 LEDs deliver 76,000 candelas at a 10° beam angle
