Archives: Projects

Network Attached Storage (NAS) are high-capacity storage devices that are connected to a local home or office network to provide everyone (with designated "clearance") on that network with access to the files on the drive without the need to plug into it directly. This facilitates things...

  This project consists of 20 non-contact infrared reflective sensors and each sensor provides an analog output. QRD114 sensor is the heart of the project which includes Infrared LED and photosensor.  The output of each sensor is high and goes low as objects or lines...

I'm quite passionate about air quality monitoring, so whenever I see an interesting air quality monitoring project that could help people stay healthy, while also serving as a good way to learn DIY electronics, I'm always eager to share.  Thus, for today's tutorial, I will chronicle the...

This project has been developed to charge SLA (Lead Acid Batteries) . It helps to charge 12V Lead-acid battery up to 12Ah in capacity. Specific current output is possible by altering the current sense resistor.  The BQ24450 chip contains all the necessary circuitry to optimally...

This USB to dual output step-up DC-DC converter has been designed to be used in industrial automation control equipment, sensors, isolated operational amplifiers and test & measurement equipment that require bipolar supply voltages. The module provides +/-15V or +/-12V DC load...

This module is a non-isolated 7A DC-DC converter. The module can convert any DC voltage between 7V to 50V to a 5V DC with load current up to 7A. The project has been designed around LM5116 Wide Range Synchronous Buck Controller IC. The design includes 6uH toroid inductor and two N...

This project is based on STK984-090A which is a fully-integrated inverter with current rating 20A and supply voltage 40V DC. It has been designed to drive the Brushless DC Motors (BLDC) and permanent magnet synchronous motors (PMSM), the module works as output driver which include...

  This small board is based on the CS5171 boost converter from ON Semiconductor. The board is configured to be used with a single 18650 LiPo battery. The circuit converts single-cell 3.7V LiPo battery voltage to 5V with a load current up to 400mA. Board has been designed to...