Tag: Brushless

3-Phase Brushless Motor Driver

This 3-Phase Brushless Motor Driver features the FAN73893 3-Phase Half-Bridge Gate Driver and 6XFDB047N10 MOSFET, delivering a compact design that supports currents up to 5A and operates within a power supply range of 12V to 60V DC. The board is equipped with a screw terminal...

Continue Reading

High Voltage 3-Phase Full-Wave PWM Brushless Motor Driver

The project presented here is a three-phase sinewave PWM driver for high-voltage brushless motors. The board is built using TB67B000AHG chip, which is a high-voltage IC capable of handling 600V. The TB67B000AHG has a 2-in-1 (MCP) structure of controller (sine-wave PWM / wide-angle...

Continue Reading

3 Phase Brushless Motor Driver using L6235

The project presented here is a 3-phase Brushless motor driver. The project consists of an L6235 device which is DMOS fully integrated 3-phase motor driver with overcurrent protection. Manufactured in BCD technology, the device combines isolated DMOS power transistors with CMOS and...

Continue Reading

3-Phase Brushless DC Sinusoidal Sensorless Fan Motor Driver

Driving a low current 3 phase brushless Sensorless DC motor is very easy with this project. This Full-wave BLDC driver project is capable to drive low current brushless fan motor without a hall sensor. 180° sinusoidal drive, high torque output, and silent drive are a few key features...

Continue Reading

PWM Temperature Controlled FAN using TC648 and NTC sensor

The project described here is a switch mode fan speed controller for use with brushed or brushless DC motors. Temperature proportional speed control is accomplished using pulse width modulation (PWM). 10K Ohms NTC is used to sense the temperature. The project is built using TC648 chip...

Continue Reading

Development board for Brushless Motor, DC Brushed Motor, AC Motors (Pre-Driver)

The project described here is a pre-driver for brushless motors with a hall sensor. The board incorporates many features like current monitor, fault, speed control, direction control motor start/stop using tactile switches, various function LEDs, 6 PWM LEDs. By combining it with a...

Continue Reading

MC33035 Brushless motor driver breakout board

The board shown here is a breakout board for MC33035 brushless motor controller. It requires an output buffer IPM module or MOSFETs to complete a closed-loop brushless motor driver circuit. MC33035 IC is the heart of the project. The board provides 6 PWM pulses as well as 6 Inverse...

Continue Reading