BLDC Motor and DC Brushed Motor Driver 

BLDC Motor and DC Brushed Motor Driver 

This BLDC motor driver board is equipped with a smart IFX007T half-bridge. The BLDC motor control project is capable to drive one BLDC motor. Alternatively, it can be used to drive one or two bi-directional DC motors (H-Bridge configuration, cascaded to support the second motor) or up...

Continue Reading
2.241
Views
0 Comments
15V to 60V – Three-Phase Brushless DC Motor Pre-Driver

15V to 60V – Three-Phase Brushless DC Motor Pre-Driver

The project presented here is a three-phase BLDC motor pre-driver. The project consists of 3x half-bridge IR2101 driver IC and 6 channel high current N-MOSFETS. The project can be configured as 3 independent half-bridges H-bridge for a brushed DC motor, or a single high current...

Continue Reading
4.523
Views
1 Comments
High voltage Half-Bridge with Current Feedback using L6390

High voltage Half-Bridge with Current Feedback using L6390

The project presented here is a versatile high voltage Half-Bridge with current feedback. The board is built using L6390 IC from ST Semiconductor. It is suitable for DC-DC converters, EHT drivers, induction heater drivers, battery chargers, LED drivers, DC motor speed controller and...

Continue Reading
4.302
Views
0 Comments
High Power Bidirectional DC Motor Driver using IFX007T

High Power Bidirectional DC Motor Driver using IFX007T

This motor driver circuit can drive a brushed DC motor with up to 250W of continuous load. The project can be controlled with the general logic IO-Ports of any microcontroller. Either an Arduino Uno or another microcontroller can be used as the control board. The project uses two...

Continue Reading
8.578
Views
0 Comments
High Voltage-Current Half Bridge Driver Using IR2153 & IGBT

High Voltage-Current Half Bridge Driver Using IR2153 & IGBT

This is an IGBT based half bridge board that has been designed for multiple applications, like Induction Heater driver, Tesla coil driver, DC-DC converters, SMPS etc. High current and high voltage IGBTs are used to serve high power requirements. Its a general purpose Half-bridge board...

Continue Reading
84.959
Views
54 Comments
High Current Discrete Half-Bridge Based on IR2104 or IR2101

High Current Discrete Half-Bridge Based on IR2104 or IR2101

This is a discrete Half-bridge driver based on IR2104 gate driver IC and low impedance high current N channel IRFP4368 MOSFETS. The IR2104 is a high voltage, high speed power MOSFET driver with independent high and low side referenced output channels. HVIC and latch immune CMOS...

Continue Reading
37.239
Views
15 Comments
Get new posts by email:
Get new posts by email:

Join 97,426 other subscribers

Archives