Tag: OPA2206

Unipolar-to-Bipolar Level Translator 0V to 5V Unipolar to ±10V Bipolar Converter

This design is intended to translate a small unipolar signal to a wide bipolar signal. A common application is to translate a 0 to 5V DAC output to a ±10V bipolar signal. All resistors are 1% but it is advisable to select 0.1% 20 ppm/°C resistors for good gain, offset accuracy, and...

Continue Reading

Voltage Attenuator

The project shown here converts bipolar +/-10V (Dual 10V) signal and provides a single-ended 0 to 5V signal. The circuit attenuates a +/-10V, 10Khz bandwidth bipolar signal converts to a single-ended signal, and also filters it by a 3rd-order Butterworth filter to drive a single-ended...

Continue Reading