login
Tag: switch
Arduino Bluetooth Relay Switch
This Bluetooth Relay Switch enables users to control lights, fans, or other devices using a Bluetooth app on an Android device. The device can be controlled using a simple app. The project consists of an Arduino-compatible microcontroller (ATMEGA328), a 5V relay, a relay driver BJT,...
Continue Reading
Arduino 8 Channels High-Side Switch
The project presented here is a high-side switch (8 channels) with MOSFET output. The Arduino board consists of an Arduino-compatible microcontroller ATMEGA328 and TPD2015FN - 8 Channels MOSFET switch. All 8 inputs of TPD2015FN are TTL compatible. The project is suitable for driving...
Continue Reading
Over Current Trip Switch – Over Current Shutdown Relay
The project presented here is an over-current trip switch. It provides protection to a load when over current condition occurs. Basically, the project trips the relay when there is a short circuit or the load starts drawing much current. When the condition is favorable, press the...
Continue Reading
Linear Actuator Controller with Limit Switch to prevent Overextension and Retraction
The project described here is a very useful device for use with linear actuators. This controller prevents the actuator from reaching the physical movement limits of the actuator, thus it prevents burnout of motor and physical/mechanical damage to the actuator itself to the mechanical...
Continue Reading
High Current MOSFET Based Power Switch with Gate Driver
This power load switch project provides a simple and inexpensive method for power control. It is intended for driving a resistive or inductive load. A TTL logic signal from the system turns the load switch ON and OFF. The project consists of a low ohm N-Channel Power Trench MOSFET...
Continue Reading
4 Tactile Switch Breakout Board
This breadboard-friendly board breaks out all 4 tactile switch signals and includes pullup resistors configured so that the outputs read low or high when configured common VCC or GND. Schematic Gerber...
Continue Reading
Infrared Remote-Controlled AC Load ON/OFF switch with SSR
Driving an AC high voltage and current load using an Infrared remote is very easy with this project. This is an open-source Arduino compatible hardware that is based on ATMEGA328 microcontroller, SSR (Solid-state Relay), Infrared Receiver TSOP1838, and analog input interface. We have...
Continue Reading
