Tag: MACH3

STEP/DIR SIGNAL TO CW/CWW SIGNAL CONVERTER FOR CNC & MOTION CONTROL SYSTEMS
ControlMotor

STEP/DIR SIGNAL TO CW/CWW SIGNAL CONVERTER FOR CNC & MOTION CONTROL SYSTEMS

Simple Circuit converts Step/Dir. signal into to double drive CW/CWW Pulse, Mach3 and few Hobby CNC software’s provides Step/Direction pulse output to drive stepper motor drivers. Various AC servo works with double CW/CCW pulse. This circuit is solution to interface such AC...

Continue Reading
6.529
Views2 Comments
Optically Isolated LPT Breakout Board for CNC & Routers
Control

Optically Isolated LPT Breakout Board for CNC & Routers

Optically isolated parallel port  break out board designed for Hobby CNC, Routers and Motion controller, This Board is an easy solution to drive stepper Motor driver through PC parallel port, The Board is compatible with various CNC software specially made for LPT port data output....

Continue Reading
5.823
Views0 Comments
Get new posts by email:
Get new posts by email:

Join 97,426 other subscribers

Archives
TagCloud
Aaeon AI Arduino ARM Battery BLE Bluetooth camera DC-DC display ESP32 ESP8266 FPGA GPS I2C IoT Kickstarter LCD Led Linux Mcu MEMS Microchip Microcontroller MOSFET Motor OLED Oscilloscope PCB Power supply PWM Raspberry Pi regulator RISC-V SBC Sensor SOC SOM STMicroelectronics Switching temperature Texas Instruments TFT USB Wifi
Subscribe to Our RSS Feed